Skip to Main Content
ADD A NEW IDEA

FILTER BY CATEGORY

Analysis

Showing 6 of 27

Allow gap supports with response spectra analysis

Response spectrum analysis is a static equivalent linear analysis to a dynamic earthquake event. AutoPIPE allows the use of V-Stops with gaps for static analysis. The condition of the gap closure and subsequent support loading is determined by eva...
Guest about 1 month ago in Analysis 0

Allow stresses from soils to be combined with other pipe stress loads in user defined combinations

Currently ring bending stresses in pipes from soil loads cannot be exported within a separate user-defined load combination (like gravity / thermal / poisson loads etc.) but has to be exported as part of a very specific pre-determined code combina...
Guest about 1 month ago in Analysis 0

100-40-40 spatial combination option

In Response Spectra Analysis, the spatial combination is always SRSS. The NRG 1.92 rev. 2 accepts as an alternative the use of the 100-40-40 method, as proposed by Newmark, to spatially combine the components. An option to select between SRSS or 1...
Edgar Flores 5 months ago in Analysis 0 Planned

Always enable "Use weight factor for bolt/nut weight" when importing a flange

When importing a PCF file please allow for the option to enabler "Use weight factor for bolt/nut weight" for flanges
Guest 8 months ago in Analysis 0

Use AutoPIPE valve weights when importing PCF files

When importing files (such as PCF's) please provide the option to use AutoPIPE valve weights rather than using the weights from the original design tool that created the PCF file. Essentially having the option to automatically enable the "valve wr...
Guest 8 months ago in Analysis 0

CMB Files keep dropping off after importing

The load combinations keep having to be updated by re-importing the CMB file constantly when doing the analysis. Making the imported CMB files more stable to where the user do not have to keep re-importing them so often would be a good idea to imp...
F T 11 months ago in Analysis 1