ADD A NEW IDEA

FILTER BY CATEGORY

All ideas

Showing 15 of 15

When exporting a model, the user should have the ability to select which nodes are exported based on the type of element it represents.

When creating stress isometric drawings, my team typically exports a .dxf file of the AutoPIPE Model. We are only concerned with nodes that represent support locations, however, there is no option to export only support nodes. Having this option a...
Guest 4 months ago in  1

Include B31.1 2020 option

No description provided
Guest 3 months ago in Code 1 Planned

Increase tag length or remove the restriction altogether (like Caesar II)

The current max length of tags is 36 characters. Tag is meanwhile just about the only play where we can save some element-specific information. For example in the case of a Support I would like to save AT LEAST the following:1) The designation of ...
Guest about 1 month ago in Modeling 0

Flange analysis EN 1591-1

Include EN1591-1 calculations methodology for flanges / flange leakageLook through EN 13445-3 Annex G - Alternative design rules for flanges and gasketed flange connections
Guest about 2 months ago in  1 Planned

Combination Reorganization

In the screenshot in the attached link, for example, i would like to move the highlighted combinations between LC130 and LC131. Does this make sense? As far as I know, the only way to do this is to duplicate LC131 to LC148 and then delete them. Li...
Guest 4 months ago in  1

Add option to enter Specific Gravity of contents referenced to Air instead of Water

The Specific Gravity based on water is not applicable to flow services that are 100% gas. Specific gravity for liquid is weight of liquid with respect to water and specific gravity of gas is weight of gas with respect to air. These 2 fluids are to...
Guest 8 months ago in  2 Planned

Add trunnions and connected supports to Stress Isometric

Stress ISOmetric, I would like to see the trunnions shown along with their attached supportsThis will definitely save time having to annotate stress isos to show the missing pipe supports with the trunnions.
Guest 8 months ago in  2

Angle measurement

It is important to know not only the distance between the two points but also the angle of the pipe with respect to the coordinate axes during creating and modifying a model. I would like you to add another item to the Tools menu called Angle Meas...
Guest about 1 month ago in UI / Modeling 0 Planned

B31E code option

Add an option to use B31E (Standard for the Seismic Design) section 3.4 equation and the SSRS load combinations
Guest about 1 month ago in Code 1 Planned

Add TOTAL RUN TIME FEATURE/LOG to AutoPIPE Analyses

For large AutoPIPE analyses especially, it would be VERY helpful to know how long an AutoPIPE analysis took to run! I think the a log file with the time stamp, what analyses were run, and the total run time would probably be the best option. A p...
Guest about 2 months ago in  0